This kit includes 2 heat extractors designed to replace the factory plastic units. Designed specifically for 85-90 IROC recessed hood vent area and low pressure zones. Does not fit 82-84 Z28 Hoods. The louvers can be installed on any flat camaro hood, including the flat RS hoods to give your Camaro the IROC look with added heat extraction vents. These are functional hood vents which require holes to be cut into your existing hood panel.Included in kit: Templates for cutting, rivets, washers, installation instructions, and any necessary spacers for a factory style installation. Optimized louver design to maximize extraction flow velocities within a vehicle in motion. Reduces under hood pressure delta to reduce front end lift and increase net vehicle downforce. Significantly reduces under hood temperatures by extracting heat and allowing fresh cold air to enter the engine bay. Maximize life of engine accessories by reducing overall operating temperature. Increases dense, cold air flow through radiator to promote lower coolant temperatures. Louver backbone design maintains hood structural rigidity. Contoured to fit your specific hood curve. Installs easily with supplied templates. Included in kit: Templates for cutting, rivets, washers, installation instructions, and necessary spacers for a factory quality installation. The item "1985-1990 Camaro Z28 IROC-Z IROC Trackspec Vented Heat Extractor Hood Louvers" is in sale since Friday, December 4, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Exterior\Hoods".
The seller is "hawksmotorsports" and is located in Easley, South Carolina. This item can be shipped to United States, Canada.